国产AV一区二区三区传媒,亚洲无码av在线高清,最近更新中文字幕7

Screw cold heading machine how to deal with the phenomenon occurs breakage

1, first clear the surface of the sludge off the screw breakage gun with the center of the center section of gun death and then use an electric drill fitted with a diameter of 6-8 mm pistol drill drill hole in the center section, note the hole must be drilled through. After the drill hole, the small drill bit is removed and replaced 16 mm diameter drill holes continue to expand and drill off the bolt.
    2, take a diameter of 3.2 mm or less in the current electrodes using small broken bolt drill holes from the inside to the outside of the site began surfacing surfacing take off half of the entire length of the bolt can be. At the start of welding arc not too long so as not to burn off the outer bolts. surfacing to end face-off bolts and then continue to the surfacing of a diameter of 8-10 mm, 14-16 mm high cylinder.
    3, surfacing after a good hand hammer hammering at its end face so that the bolt breaks along its axial vibration generated due to the heat generated by the arc on the previous and subsequent cooling coupled with the shock will break at this time and the body of the threaded bolt loosening between.
    4, careful observation can take M18 nut set in the surfacing of stigma and welding when the two found a trace of rust after a tap leaking from the fracture time.
    5, after the cool hot welding set with wrenches on the nuts around the edge back and forth back and forth twisting can twist side with a small hand percussion hammer nut end face so you can remove the broken bolt.
    6, after removing the bolts breaking hammer with a suitable wire threaded processing rack inside the hole again to remove rust and other debris.

·Cold heading machine safety procedures

2015-12-21

·How cold heading machine equipment failure treatment

2015-12-21

·Project Management Body of Knowledge: cold heading machine, steel drawing machine inspection requirements

2015-12-21

·China rolling machine outdone breakthrough technology bottleneck

2015-12-21

High-speed molding machines and large machine business, please contact:
Wuxi City is Yao Machinery Co., Ltd.
Mr. Meng Yuheng
Mobile: 13915388305
Tel: 0510-87128590
Address: Wai Hing Road, Yixing City Economic Development Zone

Normal molding machines and double-click the entire molding machine business, please contact:
Wuxi City is Yao Machinery Co., Ltd.
Mr. Zhang Jiucheng
Mobile: 13806152202
Tel: 0510-87581301
Address: Yixing City Town East 2 km

Foundry business, please contact:
Wuxi City is Yao Machinery Co., Ltd.
Mr. Zhuang Bingjiang
Mobile: 13806155300
Tel: 0510-87868638
Address: Qi Eshan Town, Yixing City Industrial Zone

大陆精大陆国产国语精品,高跟肉丝少妇A片在线,欧美视频一区二区三区,免费观看WWW成人A片,免费午夜扒丝袜www在线看